Glidden Porch & Floor Interior/Exterior Paint and Primer, Light Gray, 1 Gallon, Satin

Glidden Porch & Floor Grab-N-Go Interior/Exterior Paint and Primer, Light Gray, 1 Gallon, Satin is designed to enhance your wood and concrete surfaces, especially floors, steps and railings and can also be used on properly prepared horizontal masonry, wood and metal substrates. Find it in our most popular ready mix colors or have it tinted to match your favorite Glidden colors. Available in one gallon size.

Glidden Porch and Floor Grab-N-Go Paint and Primer, Satin Finish:

• Ready-mixed paint
• Glidden gripper grey primer has high durability
• Scratch resistant
• Easy application
• Fast drying
• Guaranteed results
• Can be used on wood or concrete surfaces
• 1 Gallon covers 300-400 sq ft
• Can also be used on properly prepared horizontal masonry, wood and metal substrates

Application:

• Stir thoroughly. When using more than one container, intermix to ensure color uniformity.
• Application Method: Apply with a high quality brush, roller or airless sprayer. Two coats are suggested for best results.
• Application Equipment: For smooth surfaces, use a polyester nylon brush or 3/16” – 3/8” nap roller cover. For airless spray, use a .015”-.019” tip at 2000 psi, adjust pressure as needed. 
• Spray equipment must be handled with due care and in accordance with manufacturer’s recommen- dation. High-pressure injection of coatings into the skin by airless equipment may cause serious injury.
• Thinning: DO NOT THIN.

Application Temperature:

• Material: 50 to 90°F (10 to 32°C) Ambient: 50 to 90°F (10 to 32°C) Substrate: 50 to 90°F (10 to 32°C)

Drying Time:

• Dry time @77°F (25°C) & 50% relative humidity.
• To Touch: 2-4 hours
• To Recoat: 8 hours
• Light Foot Traffic: 24 hours
• To Full Cure: 30 days
• Drying times listed may vary depending on temperature, humidity, film build, color, and air movement. 

Coverage:

• One gallon (3.78 Liters) covers approximately 300 – 350 sq. ft. (28-33 sq. meters) per U.S. gallon (3.78 L) on primed, smooth non-porous surfaces.
• Wet Film Thickness: 4.6 – 5.3 mils 
• Wet Microns: 117 – 135
• Dry Film Thickness: 1.9 – 2.2 mils
• Dry Microns: 48-56
• Coverage figures do not include loss due to surface irregularities and porosity or material loss due to application method or mixing. Some colors, drastic color changes, or porous substrates may require more than one coat to achieve a uniform finish.

Cleanup: 

• Clean tools with warm, soapy water. Clean spills immediately with a damp cloth.

Recommended Substrates:

• Concrete/Masonry
• Wood
• Metal

Warning: 

• CONCRETE/MASONRY: New concrete should cure for at least 30 days and preferably 90 days prior to priming and painting. The pH of the sub-strate must be less than 10.
• FERROUS METAL: The surface must be cleaned thoroughly to remove dust, rust, and surface contaminants, and then primed.
• WOOD: Unpainted wood or wood in poor condition should be sanded smooth and wiped clean. Any knots or resinous areas must be sealed before painting. Countersink all nails, putty flush with surface, then prime.