Test for 12 different drugs: Marijuana THC, Cocaine COC, Opiate OPI, Methamphetamine MET, Oxycodone OXY, Amphetamine AMP, Barbiturates BAR, Benzodiazepines BZO, Methadone MTD, Methylenedioxymethamphetamine MDMA, Phencyclidine PCP, Propoxyphene PPX. No. Any Test Line, no matter how dark or light is considered a negative result and should not be interpreted as a measure of the number of drugs. The intensity of the lines may vary due to a variety of factors: How diluted in the urine, the pH or protein level of the urine, and interference from a metabolite in the urine that closely resembles the drug. Most drugs can be detected in the urine within a few hours after taking the drug; However this can vary depending on the type of drug taken, the amount taken, the frequency of use, and the metabolism of the person being tested. Each drug is cleared by the body at different rates. Some drugs, for example, THC, can stay in the body for up to several weeks after use. EZ Level drug testing products are more than 99 percent accurate in detecting specific drugs in urine. The accuracy of the test depends on several factors such as how close to the cut-off level the drug is in your urine, how soon the test was administered after ingesting a drug and how much of the drug was used or ingested.
- Positive: A rose-pink band is visible in each control region. It indicates a positive result for the corresponding drug of that specific test zone
- Negative: A rose-pink band is visible in each control region and the appropriate test region. It indicates that the concentration of the corresponding drug in that specific test zone is zero or below the detection limit of the test
- Invalid: If a color band is not visible in each of the control regions or a color band is only visible in each of the test regions, the test is invalid
- Easy to use, accurate, and highly reliable 12-panel urine drug test kit
- Over 99% accurate in detecting specific drugs according to the designated cut-off levels
- Ideal for home, school, college, or work testing
- Read results in minutes
- Remove the testing device from the foil pouch and take off the cap at room temperature
- Hold the device and immerse the absorbent end into the urine sample for about 10 seconds
- Lay the device flat on a clean, dry, non-absorbent surface
Reviews
There are no reviews yet.