- Direction:
- Step1. The item must be mounted on a clean,smooth ,non porous surface.Ensure the surface is in good comdition and clean using non abrasive soap and water.
- Step2. Inspect the rubber suction pads to ensure they are smooth and free from defects.Clean using on abrasive soap and water.
- Step3. Ensure the suction cup os wholly within the tile and does not cross any grout lines.
- Step4. With the tabs in the raised poisiton,press the Bath or Shower Support Bar firmly on to the surface.This will expel air from under the suction cup.
- Step5. Press the tabs all the way down to ensure an air tight seal.
- Step6. Repeat Step4 and Step5 on the other side of the Support Bar.
- Step7. Ensure the Support Bar is securely attached before use.
- PS: If the rubber suction pad is hard, you can use boiling water to burn it .
- If you use it on the uneven surface of the brick,which may make the air come in,this will consequently make the suction pad unstable.
- NOTE:Ensure you have read the installation warnings and instructions prior use.
- Features:
- This is a brand new and Shower Handle.
- Suitable for bath or shower for extra security.
- Ideal for security to any vertical or horizontal surface in seconds.
- No Installation required, no drilling or holes
- Can easily be removed and relocated.
- Flip-up tabs create vacuum to securely hold the handle in place
- Package included:
- 2 pcs Shower Support Handle Bar
- Material:Plastic
- Size(L x W x H):12x4x4inch
- No Installation required, no drilling or holes.
- Suitable for bath or shower for extra security.
- Ideal for security to any vertical or horizontal surface in seconds.
- Material:Plastic
- Size(L x W x H):12x4x4inch
- No Installation required, no drilling or holes.
- Suitable for bath or shower for extra security.
- Ideal for security to any vertical or horizontal surface in seconds.
Reviews
There are no reviews yet.